On the LNA side, model ARF1200Q2 is a low-noise/driver amplifier that serves high-data-rate applications with 22 dB of linear ...

Here is a high performance radio receiver antenna amplifier for the entire VHF broadcast and PMR band (100-175 MHz) which can be successfully built without any special test equipment. The ...

Through a single service agreement, AAT will take end-to-end responsibility for transmission system performance. Matt Rigdon, ...

depending on the antenna length, ground connection, and radio station, it can be quite hard to hear. Even though it is cheating, [Steven] decided to make an amplifier for all the different crystal ...

This tv antenna amplifier can be used even as an fm receiver amplifier because it has a wideband amplification, so if you don’t use it for the tv set you can receive your favorite radio stations in ...

Amplifier The weak signal from the microphone ... An antenna picks up the the radio wave. If the antenna is far from the transmitter, the signal is very weak. The radio signal is cut in half.

[Will] recently tipped us about a 400MHz Low Noise Amplifier (LNA) module he made. His detailed write-up starts by explaining the theory behind an amplifying chain. Assuming a 50 Ohm antenna ...

After having expressed its intent to sell in January, Howell Laboratories has sold Shively Labs to American Amplifier ... 1963 by radio electronic pioneer Ed Shively. The company says “Ed was ...

Broken antennas get stuck all the way up, all the way down, or often somewhere in between. The shabby appearance of, and stunted radio reception on, an otherwise perfectly good car means that ...

For example, some masthead amplifiers are also distribution amplifiers. Some can also combine television and FM radio signals. If you are experiencing pixellation or picture break up, it may be ...

Now we may be on the verge of so-called "atomic radio," thanks to the development of a new type of antenna capable of receiving signals across a much wider range of frequencies (more than four ...