Here is a box that I have + some flexible wires: Another thing that you should know is that the integrated circuits are connected like this on a breadboard and as you can see the green dots show where ...

With its push connections, the breadboard enables electronics experimentation ... behind this process is replacing point-to-point jumper wires with custom cables, made using 0.1″ pitch headers ...

Snap headers. Breakaway header pins are used to connect the wiring to the Arduino and breadboard. Be sure to get the double-long header pins, which are long on both sides of the center barrier.

They’re not ideal for certain types of circuits, of course, but that’s less of a problem than those jumper wires ... is to adapt a standard breadboard so that connections between arbitrary ...

Push the L293D motor controller into the breadboard, then connect your jumper wires to the pins on the Pi and on the breadboard (see the diagram below). Connect the two wires on each DC motor to ...

1. Connect both servos’ red wires to the + 5V rail, and their brown wires to GND on the breadboard. 2. Connect one of the servo’s yellow signal wires directly to Arduino pin 9, and the other ...