June 2022 Two papers from our group received 2021 IEEE Transactions on Power Electronics Prize Paper Awards! M. Chen and C. R. Sullivan, “Unified Models for Coupled Inductors Applied to Multiphase PWM ...

High input impedance, low noise, high common mode rejection ratio (CMRR), and ultralow power are the most important performance indicators in the design of analog front end (AFE) for wearable ...

An operational amplifier or op-amp is simply a linear Integrated Circuit (IC) having multiple-terminals. The op-amp can be considered to be a voltage amplifying device that is designed to be used with ...

Wire bonding is widely used in electronic devices, the semiconductor industry, and microelectronics. It enables interconnections between the die and other electronic components in an integrated ...

A differential VO 2 oscillator has been proposed (Shamsi et al., 2021). It resorts to coupling two oscillators capacitively to force both outputs to be out of phase (180° apart). It allows for ...

This simulation shows 54-deg. phase margin, which, from Figure 1, should give a close- loop gain of 1 SSBW extension to 7.79 MHz*1.61 = 12.54 MHz. The gain of 1 simulation in Figure 3 shows a 13.6 ...

Both devices enable safe monitoring of high-voltage circuits in harsh environments while protecting analog and digital measurement circuitry.

Just like the CFA op amp capacitive load case, the response to the cap load is combination of whatever might be happening across the output pins then rolled off by the RC filter to the load. The ...

The fully differential amplifier (FDA) has emerged as a very popular last-stage interface to differential-input analog-to-digital converters (ADCs) spanning the range from 24-bit delta-sigma, 18- to ...